Montag, 18. Mai 2020

 Laden Sie diese hilfreiche Infografik zu einem empfohlenen zweistufigen Filter-Upgrade herunter. (PDF Link).

 

Ihr Gebäude erfordert Sicherheitsüberprüfungen vor der Wiedereröffnung nach einer Ausfallzeit. Um Sie bei Ihrer Vorbereitung zu unterstützen, haben wir Handlungsempfehlungen zusammengestellt, die Sie  bei der Einhaltung der erforderlichen Luftreinheit innerhalb Ihres Gebäudes unterstützten.

1. Reinigen Sie gründlich alle Böden, Theken sowie sonstige Oberflächen und sorgen Sie für saubere Raumluft gemäß den Vorschlägen der European Ventilation Hygiene Association.
2. Ersetzen Sie vorhandene Luftfilter durch saubere Filter, bevor Sie Ihr HLK-System wieder mit normaler Kapazität betreiben.

a. Sicherheit geht vor – Beim Austausch verschmutzter Luftfilter tragen Sie bitte unbedingt Handschuhe, eine Maske und eine Schutzbrille. Achten Sie beim langsamen Entfernen der aktuellen Luftfilter darauf, Staub und Schmutz nicht vom Filter zu entfernen, da dieser wieder in den Luftstrom in Ihrem Gebäude gelangen kann.
b. Luftdichte Entsorgung  – Entsorgen sie verschmutzte Luftfilter in sicher verschlossenen Beuteln um zu verhindern, dass Dritte durch sich lösenden Staub und Partikel beeinträchtigt werden.
c. Installation sauberer Luftfilter  – Falls durch die Filterbauart nicht ohnehin eindeutig erkennbar, achten Sie bei der Installation der neuen Filter auf den Luftstrompfeil, der in Richtung des Gebläsemotors zeigen sollte. Sie finden diesen Pfeil auf dem Rahmen Ihres Luftfilters.

3. Verzichten Sie wenn möglich auf den Einsatz lokaler Umluftklimaanlagen wie Ventilatorkonvektoren und Induktionsgeräte. Diese Systeme weisen typischerweise eine Filtration mit nur sehr geringem Wirkungsgrad gegen Kleinstpartikel auf.
4. Bevor Sie Ihr Unternehmen wieder eröffnen, müssen Sie Ihr HLK-System auf ein normales Niveau hochfahren, damit die Luft einige Stunden lang zirkulieren kann, bevor Personen das Gebäude betreten.

 

Bedeutung der Luftfiltration

Ein Austausch der Außenluftfilter ist per se nicht erforderlich, da Außenluft wahrscheinlich keine signifikante Quelle für z.B. Coronaviren darstellt. Die Filter sollten jedoch gemäß den normalen Wartungsplänen ausgetauscht werden, um ein normales Luftvolumen zu gewährleisten und eine Überlastung und ein Durchblasen zu vermeiden. Experten empfehlen dennoch im Rahmen der Vorbereitung einer Wiedereröffnung nach längerer Schließung den Austausch der aktuell installierten Filter zu überdenken. In vielen Fällen fordern sie Unternehmen dringend auf, ihre Filtereffizienz zu verbessern und so Kunden und Mitarbeiter vor Partikeln aus der Luft zu schützen.

 

Krankheitserregende Partikel

Winzige Viruspartikel „reiten“ auf vergleichsweise größeren Staubpartikeln oder Tröpfchen, wenn sie sich durch ein Gebäude bewegen. Im Allgemeinen neigen Viruspartikel sich an, Partikel und Tröpfchen im Größenbereich von 0,3 bis 1,0 Mikrometer anzuhaften. Glücklicherweise fängt eine geeignete Kombination von Luftfiltern mit einer Bewertung von ePM1 oder höher mindestens 95% der in der Luft befindlichen Partikel in diesem Größenbereich ein.

 

 

Mögliche Filterkombinationen zum Filtern von mindestens 95% der ePM1-Partikel::  

Lösung mit Fokus auf geringen Systemwiderstand::
Stufe 1: DriPak SX ePM10 70%
Stufe 2: Varicel V XL ePM1 55%
Anzahl der benötigten Zirkulationen: >3


Lösung mit Fokus auf Effizienzsteigerung::
Stufe 1: DriPak SX ePM2,5 65%
Stufe 2: Varicel V XL ePM1 85%
Anzahl der benötigten Zirkulationen: >2

Unsere empfohlene Lösung für maximale Effizienz bei geringst möglicher Anzahl an Luftwechseln:
Stufe 1: DriPak NX ePM1 60%
Stufe 2: BioCel V (H)XLA 95, E10 with 98% efficiency on ePM1 particles
Anzahl der benötigten Zirkulationen:>1

 

 

Partikeleffizienz vs. Energieeffizienz 
Im Allgemeinen können Sie davon ausgehen, dass eine Verbesserung der Partikeleffizienz zu einer Verringerung der Energieeffizienz führt. Neben einer höheren Energierechnung kann es auch zu zusätzlichen Abnutzungserscheinungen an Ihren HLK-Geräten kommen. Dank unseres innovativen Filterdesigns und unserer Medienoptionen ergeben sich eine Vielzahl von Möglichkeiten, die Partikeleffizienz zu verbessern, ohne den Kostenrahmen zu sprengen oder Ihre HLK-Geräte übermäßig zu belasten.

Wir sind für Sie da

AAF bietet eine Reihe von Werkzeugen und datengestützter Analysetools, wie TCO Diagnostic® und Sensor360®, an, um eine Lösung zu finden, die auf Ihre Bedürfnisse und Umstände zugeschnitten ist. Unser Prozess beginnt mit einem Facility Audit, das Ihnen Folgendes bietet:

  • Professionelle Analyse
  • Benchmarkdaten
  • Verbesserungsvorschläge für Ihre spezielle Anwendung
  • Standardisierte Liste der Luftfilter je Anlage


Wenden Sie sich an einen Vertreter in Ihrer Nähe,  um eine Beratung anzufordern, damit Sie mit einem benutzerdefinierten Luftfilter-Upgrade beginnen können.

 Download this helpful infographic on a recommended two-stage filtration upgrade.PDF icon

 

Your building requires safety checks prior to reopening after a period of downtime. To aid you in your preparation, we compiled a list of steps that you can follow to feel confident in the cleanliness of your building.

  1. Clean and sterilize all floors, counters, and even the air according to suggestions from the CDC’s COVID-19 Resources for Businesses and Employers.
  2. Prior to running your HVAC system at normal capacity again, replace existing air filters with clean filters.
    1. Safety First – Before replacing dirty air filters, first be sure to wear gloves, a mask, and safety glasses. As you slowly remove the current air filters, take care not to dislodge any of the dust and debris, which can otherwise re-enter the airstream inside your building.
    2. Bag Disposal – Now that you have removed the dirty air filters, place them into bags and seal these bags as further protection against the collected dust and particles harming people who are exposed to them.
    3. Clean Air Filters Installation – Place clean air filters inside the HVAC unit with the air flow arrow pointing toward the blower motor. You will find this air flow arrow on the frame of your air filter.
  3. View these additional tips & suggestions on filtration and disinfection of your HVAC system from ASHRAE (American Society for Heating, Refrigeration, and Air-Conditioning Engineers).
  4. Before reopening your business, ramp up your HVAC system to normal levels, allowing air to circulate for a couple of hours before people enter the building.

 

Importance of Air Filtration

As noted above, healthy buildings experts suggest replacing current air filters as part of this preparation process. In many cases, they urge businesses to upgrade their filter efficiency to capture even more small particles, helping to keep customers and employees safe from airborne particles.

 

Pathogen-carrying Particles

Tiny virus particles generally piggyback on comparatively larger dust particles or droplets as they travel through a building. In general, virus particles tend to hitch a ride on particles and droplets in the size range of 0.3 to 1.0 microns. Fortunately, air filters with a rating of MERV 16 or higher capture a minimum of 95% of airborne particles in this size range.

Piggyback virus Particles Air FIlter

The Case for Upgrading

Even better, a combination of high-efficiency air filters captures nearly all of the particles in this size range, eliminating typical virus-carrying particles from airstreams inside buildings. For example, a MERV 11 prefilter in conjunction with a MERV 16 secondary filter removes 98.66% of particles in the 0.3-1.0 micron size range in one pass. By contrast, if you rely on lower efficiency filters such as a MERV 8 prefilter with a MERV 14 secondary filter, it would take three passes through the filters to remove the same percentage of particles.

Prefilter and Secondary Filter Set UP

Particle Efficiency vs. Energy Efficiency

Generally you can expect that an upgrade in particle efficiency will cause a decrease in energy efficiency. Besides translating to a higher energy bill, you could also be faced with additional wear and tear on your HVAC equipment. However, thanks to innovative filter design and media options, you can usually find a way to upgrade your particle efficiency without breaking the bank or causing undue damage to your HVAC equipment.

 

We’re Here to Help

AAF Flanders offers a suite of air filtration tools, such as TCO Diagnostic® and Sensor360®, to identify a solution that is tailored to your needs and circumstances. Our process starts with a complimentary facility audit, which provides you with:

  • Professional analysis
  • Benchmark data
  • Ideas for improvement
  • Standardized list of air filters by air handler unit

 

Contact a representative in your area to request a FREE air filtration audit, so you can get started on a custom air filtration upgrade.

 Download this helpful infographic on a recommended two-stage filtration upgrade.PDF icon

 

Your building requires safety checks prior to reopening after a period of downtime. To aid you in your preparation, we compiled a list of steps that you can follow to feel confident in the cleanliness of your building.

  1. Clean and sterilize all floors, counters, and even the air according to suggestions from the CDC’s COVID-19 Resources for Businesses and Employers.
  2. Prior to running your HVAC system at normal capacity again, replace existing air filters with clean filters.
    1. Safety First – Before replacing dirty air filters, first be sure to wear gloves, a mask, and safety glasses. As you slowly remove the current air filters, take care not to dislodge any of the dust and debris, which can otherwise re-enter the airstream inside your building.
    2. Bag Disposal – Now that you have removed the dirty air filters, place them into bags and seal these bags as further protection against the collected dust and particles harming people who are exposed to them.
    3. Clean Air Filters Installation – Place clean air filters inside the HVAC unit with the air flow arrow pointing toward the blower motor. You will find this air flow arrow on the frame of your air filter.
  3. View these additional tips & suggestions on filtration and disinfection of your HVAC system from ASHRAE (American Society for Heating, Refrigeration, and Air-Conditioning Engineers).
  4. Before reopening your business, ramp up your HVAC system to normal levels, allowing air to circulate for a couple of hours before people enter the building.

 

Importance of Air Filtration

As noted above, healthy buildings experts suggest replacing current air filters as part of this preparation process. In many cases, they urge businesses to upgrade their filter efficiency to capture even more small particles, helping to keep customers and employees safe from airborne particles.

 

Pathogen-carrying Particles

Tiny virus particles generally piggyback on comparatively larger dust particles or droplets as they travel through a building. In general, virus particles tend to hitch a ride on particles and droplets in the size range of 0.3 to 1.0 microns. Fortunately, air filters with a rating of MERV 16 or higher capture a minimum of 95% of airborne particles in this size range.

Piggyback virus Particles Air FIlter

The Case for Upgrading

Even better, a combination of high-efficiency air filters captures nearly all of the particles in this size range, eliminating typical virus-carrying particles from airstreams inside buildings. For example, a MERV 11 prefilter in conjunction with a MERV 16 secondary filter removes 98.66% of particles in the 0.3-1.0 micron size range in one pass. By contrast, if you rely on lower efficiency filters such as a MERV 8 prefilter with a MERV 14 secondary filter, it would take three passes through the filters to remove the same percentage of particles.

Prefilter and Secondary Filter Set UP

Particle Efficiency vs. Energy Efficiency

Generally you can expect that an upgrade in particle efficiency will cause a decrease in energy efficiency. Besides translating to a higher energy bill, you could also be faced with additional wear and tear on your HVAC equipment. However, thanks to innovative filter design and media options, you can usually find a way to upgrade your particle efficiency without breaking the bank or causing undue damage to your HVAC equipment.

 

We’re Here to Help

AAF Flanders offers a suite of air filtration tools, such as TCO Diagnostic® and Sensor360®, to identify a solution that is tailored to your needs and circumstances. Our process starts with a complimentary facility audit, which provides you with:

  • Professional analysis
  • Benchmark data
  • Ideas for improvement
  • Standardized list of air filters by air handler unit

 

Contact a representative in your area to request a FREE air filtration audit, so you can get started on a custom air filtration upgrade.


 First Stage Second Stage Installed # of Circulations to 
Capture 95% ePM1
Comment
 98% ePM1  -

BioCel V HXL E10, ΔP int. 150 Pa (E10), 
592 x 592 x 440

 > 1x   Single filter, high efficiency, secure
 70% ePM10  55% ePM1  

DriPak SF ΔP, int. 90 Pa (M6)

592 x 592 x 635

---

VVXL 55% ePM1, ΔP int. 75 Pa (F7)

592 x 592 x 292

 > 3x  165 Pa system resistance
 65% ePM2,5  85% ePM1  

DriPak SX, ΔP int. 150 Pa (F7)

592 x 592 x 635

---

VVXL 85% ePM1, ΔP int. 130 Pa (F9)

592 x 592 x 292

  >2 x  280 Pa system resistance, better selection 
 possible with lower resistance and higher efficiency