Aircobra Cube Filters

view brochure

SINGLE-POCKET AND TWO-POCKET AirCobra� CUBE FILTERS

CUBE FILTER DESIGN IS IDEAL FOR A VARIETY OF APPLICATIONS

Pre-filters - to extend the life of high efficiency filters
First stage filters in hospital systems requiring 25% efficiency
Single stage filtration systems - cube filters provide long service life and excellent protection to prevent dirt build up on coils and ducts
Paint overspray collection - cube filters follow scrubbers in wet booths or follow coatings collection pads in dry booths to reduce stack emissions

TRIPLE-DENSITY, SINGLE-PIECE MEDIA DESIGN CATCHES AND HOLDS MORE DIRT

Upstream Layer
Triple-density, single-piece media with 40/15 dual denier fibers. Larger, heavier particles are caught in the 40 denier front portion of the media without faceloading. Smaller particles are caught in the 15 denier back portion.
Self-sealing Design
The media is sonically sealed around an internal wire support frame that forms a friction fit with the holding frame. The self-sealing design provides the fastest, easiest installation of any extended surface filter on the market. Simply push the filter into the frame. The polyester media forms a built-in gasket between the wire support frame and holding frame that secures the filter in place and seals it to prevent bypass. No clips, latches, or basket-type wire retainers are required.
Single-Pocket or Two-Pocket Models
Two pockets increase exposure of the media to incoming dirty air. Higher dust holding capacity extends service life. Two pocket models also provide lower initial resistance.
Pressure Sensitive, Dirt-Holding Adhesive
A non-drying adhesive designed exclusively for synthetic media is applied to the downstream layer. The adhesive prevents dirt particles from migrating through the media and blowing downstream.
Header Style
AirCobra� filters are available with a 13/16" thick U-channel header for side access installations or other systems where a header is required.